Ultrasonic Stencil Cleaner

The Aqua Klean Manual Stencil Cleaner offers exceptional stencil cleaning performance at an economical price.

Request Quote

Generic placeholder image

  • Complete cleaning Microscopic, ultrasonic removal of solder paste, post solder flux build-up, and more
  • All-in-one cleaning All workstations included in one compact unit, minimizing required floorspace
  • Easy loading and unloading Low-profile, top-centric design requires no or minimal bending
  • Portability The entire systems moves easily around your shop on sturdy wheels
  • Conservation of detergent From wash station filter that extends chemical life
  • Conservation of waste water From closed-loop filtration system
  • Easy maintenance With easy-to-access, easy-to-replace parts

  • MAXIMIZE YOUR STENCIL CLEANING RESULTS!

    The AKS Stencil Cleaner is a world-class ultrasonic stencil cleaning system. It provides manufacturers with excellent cleaning performance while meeting budget and floor space requirements. Ideal size for multi-workstation set-up, the AKS Stencil Cleaner requires minimal space while delivering uncompromising cleaning results. If budget, floorspace, or multiple workstations are required, look no further than Aqua Klean's ultrasonic stencil cleaning system.
    Easy to program and operate, simply place your stencil in the rack and press the start button. The stencil cleaner will lower your stencil into the wash tank, which is filled with high quality detergent, and is ultrasonically cleaned by high-speed microscopic bubble implosions. After only a few minutes, it then lifts your cleaned stencil from the wash, and you spray-clean by hand to remove the loosened solder paste and other contaminants. Last, you use a low-pressure dry air gun removes the remnant rinse moisture and your stencil is ready to be used again all in only a few minutes time!
    First Sump Dimensions 31" left to right by 6" front to back by 26.75" deep (24.75" liquid depth)
    First Sump Capacity 20 Gallons
    Second Sump Dimensions 31" left to right by 10" front to back by 30.5" deep (27.5" liquid depth)
    Second Sump Capacity 37 Gallons
    Overall Dimensions 40.75" left to right by 33.5" front to back by 36.5" high
    Process Wash, Rinse
    Chemistry Water
    Facilities 1-3 GPM (4-6 GPM on demand) DIW@ 1-2 Mohm, 30-35 psi and process temperature, 65-70 CFM CDA @ 30 psi, 1-2 CFM shop air @ 60 psi, unrestricted floor drain
    Power Requirements 240 volts/60 Hz/1 phase, 25 amps
    Ultrasonic Frequency 40 kHz
    Ultrasonic Density 50 Watts Per Gallon
    Ultrasonic Timer An analog panel-mounted timer with buzzer
    Heat 4000 Watts of strip heat at first pump
    Temperature Control A 0-250°F panel mounted thermostat
    Blow Off A PVDF air blow off gun with 6ft stainless steel braided hose. Include a filter regulator with gauge
    Spray Rinse A PVDF spray gun with 6ft stainless steel braided hose
    Standard Features Stainless steel lift off covers, A float-type low liquid level safety, A capillary bulb-type over temperature safety thermostat
    Basket Mesh basket size 29” X 5” X 26.25” with built-in drip handles
    Tank Material Type 316L stainless steel with a #2B finish
    Cart Material Powder coated black roll around cart with fitted casters
    Plumbing Complete hard plumbed process piping with all appropriate flow control and isolation ball valves
    Electrical A NEMA 12 enclosure with all the control mounts to the right side of the console
    ...